FIBREFLOW ACCESSORIES

Our range of accessories to complete your solution and assist in a smooth installation of FibreFlow.

FibreFlow Connectivity

FIST-EDSA

CommScope FIST-EDSA fibre optical splice and patch closure. The closure is a bespoke solution for termination and patch customer connection onto pre-installed internal patch panel. The panel support up to 48 customer connections.

TENIO

CommScope TENIO fibre optical splice closure with fast toolless mechanical cable sealing. Modular design to suite a wide range of cable and splicing application. With 2 standard sizes supporting up to144 splices or larger up to 288 splices.

FLAT-FIST

FIST GC02-F is a generic environmentally sealed enclosure for the fibre management system that provides the functions of splice and passive component integration in the external network.

OFDC 1

CommScope OFDC fibre optical splice closure range is designed to support a wide range of distribution and drop cable. Modular and suitable for splicing or connectorised drop cable. Compact design suitable for aerial or underground deployment.

Connectors & End Caps

Push Fit Connector

Clear push-fit tube connectors, end caps and reducer connectors suitable for use with FibreFlow microduct to ensure a seamless and airtight connection while blowing fibre cable or fibre bundle.

Gas Block

Gas Block connectors provides an in-line seal between the connector, tube and fibre cable preventing gas and water from entering the cable system and leaking into unwanted areas.

Blown Fibre Push-Fit Connector

Clear push-fit tube connectors, end caps and reducer connectors suitable for use with FibreFlow microduct to ensure a seamless and airtight connection while blowing fibre cable or fibre bundle.

Protected Connectors, End Caps

Clear push-fit tube connectors and end caps with rugged protected cover / tube lock suitable for use with FibreFlow microduct to ensure a seamless and airtight connection while blowing fibre cable or fibre bundle.

FibreFlow Overhead

Universal Pole Bracket

High mechanical strength aluminium alloy bracket for anchoring various aerial hardware onto all types of infrastructure poles.

Cable Clamp

Wedge style cable clamp suitable for anchoring circular dropwires. Has tapered grip action using jaws that grip the insulation over the dropwire. Use predominantly on figure -8 aerial cables.

Cable Clamp

Wedge style cable clamp suitable for anchoring circular dropwires. Has tapered grip action using jaws that grip the insulation over the dropwire. Use predominantly on figure -8 aerial cables.

Galvanised Helical Drop Clamp

Galvanised steel helical warped -dead end- cable clamp design to warp around aerial cables to tie-off cables onto pole brackets and drop anchoring points.

FibreFlow Installation Equipment

AccelAir2

AccelAir2 cable blowing machine. Electrical motor with maximum installation speed of 100meters per minute while operating at 15bar pressure. Supports diameters of 5mm to 8mm duct with 1.0mm to 3.0mm cable. Support buckle detection and automatic blowing of 1.0mm to 1.6mm cable.

Air-Flow Meter Kit

Air-Flow meter kit with all accessories required to measure the air flow in a microduct system. Adequate air flow is required to ensure a cable can be blown into a duct system.

Pan Guide

Mechanical guide that can be easily attached to a FibreFlow blowing pan. The guide ensures a steady feed of fibre bundle during cable blowing and eliminates snags that can cause damage to the fibre bundle.

Inversion Ring

The inversion ring is a FibreFlow tool specifically made for FibreFlow blowing pans. This tool ensures a seamless connection between 2 pans during a fibre inversion procedure.

Subscribe to our Newsletter